Ap3g2k9w7tar1524jb6tar Hot! Download Full Jun 2026
It looks like you’re trying to locate and download a specific Cisco wireless access point firmware image: ap3g2-k9w7-tar.152-4.JB6.tar This is for the Cisco Aironet 3600/3700 series APs (AP3G2) running the “k9w7” lightweight/bundle image (not the autonomous “k9w8” type). The version is 15.2(4)JB6 . Below is a full, detailed guide to legally downloading this file and applying it.
1. Verify you have the right file name The full filename you gave is: ap3g2-k9w7-tar.152-4.JB6.tar (Your text says ap3g2k9w7tar1524jb6tar — that’s just missing dots/dashes.) Correct naming structure:
ap3g2 – AP model series k9w7 – lightweight AP image (requires controller) tar – bundle format (contains both bootloader + FW) 152-4.JB6 – software version 15.2(4)JB6
2. Where to download it (legally) You must have a valid Cisco Service Contract (SMARTnet) or a Cisco.com account with download privileges for AP3G2. Official Cisco Software Download Center: → https://software.cisco.com/download/home Step-by-step: ap3g2k9w7tar1524jb6tar download full
Log in with your Cisco.com credentials. Navigate: Wireless → Access Points → Aironet 3600 Series (or 3700) → click Access Point Software Filter by release: 15.2(4)JB6 Look for file: ap3g2-k9w7-tar.152-4.JB6.tar Download the .tar file (approx 12–15 MB).
If you don’t have a contract, Cisco will not allow the download. In that case, you must obtain the file from a partner, your support provider, or from an AP that already has it ( show flash ).
3. Alternative: Extract from a controller If you have a Cisco Wireless LAN Controller (WLC) running AireOS 8.0.x – 8.5.x that already has this AP image, you can download it directly from the WLC via HTTP/TFTP. On WLC CLI: show ap image version all It looks like you’re trying to locate and
If the version exists, you can pull the image from: https://<WLC-IP>/images/ap3g2-k9w7-tar.152-4.JB6.tar But this requires enabling HTTP/HTTPS file access on the WLC.
4. Installing the image on an AP Method A: Controller pushes image (recommended)
Upload .tar file to WLC’s flash via TFTP/FTP. On WLC: Wireless → Access Points → Global Configuration → AP Image Download → set AP Image Download Priority = Primary WLC will automatically upgrade APs joining with older version. you’d use: archive download-sw /overwrite tftp://&
Method B: Manual upgrade via AP console If AP is in autonomous mode (unlikely with k9w7 — but you can convert), you’d use: archive download-sw /overwrite tftp://<tftp-server>/ap3g2-k9w7-tar.152-4.JB6.tar
For lightweight APs (k9w7), they don’t accept manual archive download-sw – they must be managed by a controller.
