Trimble Tsc3 User Manual [exclusive] Jun 2026

Set the field to your specific receiver serial number.

The unit came back to life. Elias didn't wait. He quickly keyed in the project name: KLONDIKE_BRIDGE_V2 . trimble tsc3 user manual

4.2-inch VGA sunlight-readable touchscreen (640 x 480 pixels) Battery: Rechargeable Li-Ion (11.1 V, 2600 mAh, 28.9 Wh) Set the field to your specific receiver serial number

Clean the edges of the screen where dirt can lodge under the bezel and trick the digitizer into thinking it is constantly being pressed. If that fails, perform a hard reset by holding down the power button for 7 seconds. Issue 2: Battery Drains Rapidly He quickly keyed in the project name: KLONDIKE_BRIDGE_V2

"Sarah," he keyed the mic. "Point A is down. Moving to B."

Most surveying operations on the TSC3 happen inside software. Creating a New Job Open Trimble Access from the main menu. Tap General Survey > Jobs > New Job . Enter a unique Job Name. Select your Coord. System (Coordinate System): Select from library (e.g., local State Plane zone). Key in parameters manually.

| Action | Key / Gesture | |--------|----------------| | Power on/off | Hold Power button (3 sec) | | Suspend | Quick press Power | | Measure / OK | Enter key (green check) | | Escape / Cancel | Red X key | | Screen brightness | Fn + Up/Down | | Soft reset | Windows + Power (10 sec) | | Take photo | Camera button (right side) |