Simrad Rf300 Installation Manual __top__ -

Once mechanics and electronics are secured, you must calibrate the rudder feedback unit through your Simrad autopilot controller (e.g., AP24, AP44, or an NSS/NSX/NSO multifunction display). Step-by-Step Software Calibration

After physical installation, the system must be calibrated via the autopilot control head or multifunction display (MFD). simrad rf300 installation manual

The attached 10-meter cable contains two active wires. The polarity is critical for proper operation: Wire Color Signal Function Autopilot Computer Terminal Positive (+) Signal / Supply Rudder Feedback Plus ( FB + ) / FREQ White Negative (-) Return / Ground Rudder Feedback Minus ( FB - ) / GND Once mechanics and electronics are secured, you must

Ensure the distance between the rudder stock center and the RF300 shaft center matches the length of the linkage rod. 2. Establish Electrical Midships Alignment The polarity is critical for proper operation: Wire

The RF300 draws max 50 mA at 12V DC from the NMEA 2000 bus. No separate power connection is required.